kinmander Posted March 17, 2008 Share Posted March 17, 2008 Let me explain the steps that I did and see if anyone can figure out my problem. Booted into Zephs Lepord amd rv2 went to disk utilitys and turned my 2 partitioned hard drive into a single partition "extended journal, and master boot option" Installed to hard drive. Install suceeded. Take out disk and reboot. System sticks with a blinking underscore on the top left corner of screen. It is not loading the OS. Any Ideas on how to fix this? Link to comment Share on other sites More sharing options...
komeet Posted March 17, 2008 Share Posted March 17, 2008 Check if your partition has been set active. Use this guide to figure out how you can do that: http://osx86.wikidot.com/known-issues#toc3 Link to comment Share on other sites More sharing options...
kinmander Posted March 18, 2008 Author Share Posted March 18, 2008 Let me give this another shot. Another step that I did find that was missed was the custom install. Still had the blinking "_" after getting the right files in. I will run another installation and apply the code that you found for me. Hope this works . Link to comment Share on other sites More sharing options...
kinmander Posted March 19, 2008 Author Share Posted March 19, 2008 Well for some reason I can not get the install to finish. I even re-installed on top of the old install without going through disk utilities. Tried many many times. This just started happening for some reason. Well, instead of using Zeph's ver2 for my amd, is there another one that anyone would suggest? One that may work. I have SSE3 laptop I'm trying to put this on. HP pavillion dv9000 Link to comment Share on other sites More sharing options...
flyindman Posted January 13, 2009 Share Posted January 13, 2009 I have a dv9000z AMD and Leo4All 4.1 AMD works for me. Link to comment Share on other sites More sharing options...
Recommended Posts