ccvisabg Posted November 20, 2023 Share Posted November 20, 2023 (edited) Hello, i successfully managed to install Ventura but one of my nvme disks which was working under Catalina is not showing up in DiskUtility. I can see the disk in hackintool. 0D:00.0 1CC1 8201 1CC1 8201 Disabl ADATA Technology Co., Ltd. XPG SX8200 Pro PCIe Gen3x4 M.2 2280 Solid State Dr Mass storage control Non-Volatile memory 0/DP00@0/NV00@0 pci1cc1,8201 PciRoot(0x0)/Pci(0x2,0x1)/Pci(0x0,0x0)/Pci(0x8,0x0)/Pci(0x0,0x0)/Pci(0x0,0x0)/Pci(0x0,0x0) I tried to add that route to config.plist with no result. I did regenerate USB map again just to be sure that all is ok but still no success. pcidevices.plist pcidevices.txt Edited November 20, 2023 by ccvisabg Link to comment Share on other sites More sharing options...
cankiulascmnfye Posted November 20, 2023 Share Posted November 20, 2023 (edited) Probably because it sits behinds multiple levels of PCI bridges. You can use SSDTTime to fix this. It can generate an SSDT-BRIDGE by analyzing your System's DSDT Edited November 20, 2023 by cankiulascmnfye Link to comment Share on other sites More sharing options...
ccvisabg Posted November 20, 2023 Author Share Posted November 20, 2023 (edited) It says bridge is not needed. Gathering ACPI devices... Generating device paths... Matching against PciRoot(0x0)/Pci(0x2,0x1)/Pci(0x0,0x0)/Pci(0x8,0x0)/Pci(0x0,0x0)/Pci(0x0,0x0)/Pci(0x0,0x0) Matched \_SB.PCI0.GPP7.UP00.DP40.UP00.DP00.NV00 - PciRoot(0x0)/Pci(0x2,0x1)/Pci(0x0,0x0)/Pci(0x8,0x0)/Pci(0x0,0x0)/Pci(0x0,0x0)/Pci(0x0,0x0) - No bridge needed! Edited November 20, 2023 by ccvisabg Link to comment Share on other sites More sharing options...
Recommended Posts