Jump to content

[pre-release] macOS Ventura


3,556 posts in this topic

Recommended Posts

37 minutes ago, antuneddu said:

Honestly, it has already been 2 or 3 updates that you do not need to disable it 🤷‍♂️ ... No hitch 

Ok, then something maybe slightly off on my z590 setup but like I said, the install failed twice until I disabled it.

Edited by eSaF
  • Like 3
Link to comment
Share on other sites

Another update that is a no show for me... unenroll and enroll seed beta don't solve the problem... maybe tomorrow it shows itself, I hope...

Edited by MorenoAv
  • Like 1
  • Confused 3
  • Sad 1
Link to comment
Share on other sites

2 minutes ago, MorenoAv said:

Another update that is a no show for me... unenroll and enroll seed beta don't solve the problem... maybe tomorrow it shows itself, I hope...

 

Same as me. I still use MacBookPro11,4 with Haswell and I was told that I don't need to change it to receive updates, but I still don't.

  • Like 1
Link to comment
Share on other sites

Hello, Managed to solve some problems in my system and updated also without problems to beta 10. The only thing I have noticed and this is somewhat strange is that when I grant full disk access to certain programs like Qbittorrent. The program can only write to the main Mac OS ssd and no longer to other hard disks in my system. Is there anybody else here who has similar experience and if so did you find a solution?

  • Like 2
Link to comment
Share on other sites

2 hours ago, MorenoAv said:

Another update that is a no show for me... unenroll and enroll seed beta don't solve the problem... maybe tomorrow it shows itself, I hope...

Is your SecureBootModel set to Deafault?

Mine wasnt, after i changed it to default i started getting updates.

 

  • Like 2
Link to comment
Share on other sites

2 hours ago, MorenoAv said:

Another update that is a no show for me... unenroll and enroll seed beta don't solve the problem... maybe tomorrow it shows itself, I hope...

Just set with OpenCore Configurator => SecureBootModel = Default.

Reset NVRAM.

Try again.image.thumb.png.7bab15b268275c6963f3abe58ec6c557.png

Edited by fernando.c.neves
  • Like 1
Link to comment
Share on other sites

Thanks guys, my SecureBootModel was Default, but I had lag in safari and decided to re-install macOS Ventura, after that I was able to do the update to beta 10.

I think all is well now...

  • Like 5
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...