Jump to content

[Sold] Red, pre-modded Power Mac G5 case with PSU and I/O cable (like new)


cb55555
 Share

6 posts in this topic

Recommended Posts

post-1612460-0-50343900-1446156224_thumb.jpgI have this case listed on eBay, but I thought I'd post it here too.
 
You will receive the following:

  • Modded PowerMac G5 case, anodized in red
  • ATX motherboard tray from Mountain Mods (installed)
  • 600W Corsair CX600 power supply unit (installed)
  • 2 x 80mm case fans (installed) (If you need additional fans, the case has room, but you may need to do some additional modding yourself.)
  • HDD/SSD tool-less dock--holds up to 1 HDD and 2 SSDs (not included)
  • Front panel to ATX I/O cable (made by AlohaCab)
  • Original Plexiglas shield

I put a lot of money and time into this project, and I'm just looking to get back my costs plus a little extra for the countless hours I spent on it.
 
I'm asking $420 OBO + actual shipping costs.

 

All the hard work of modding the case has already been done, and it's ready for assembly.

 

Let me know if you have any questions.

 

post-1612460-0-31227000-1446156222_thumb.jpg

post-1612460-0-83950400-1446156223_thumb.jpg

post-1612460-0-14765100-1446156225_thumb.jpg

post-1612460-0-63841900-1446156225_thumb.jpg

post-1612460-0-12338400-1446156226_thumb.jpg

post-1612460-0-87148200-1446156968_thumb.jpg

  • Like 5
Link to comment
Share on other sites

Very good Mod !!

Only a question: Why Red ??

 

Well, apples are red. :)

 

Actually, I had 3 cases, and my original plan was to get each one refinished in a different color: black, blue, and red. The black one got messed up, so I had the 2nd one done in black as well, and had the 3rd one done in red. It turns out the red one looked the best, so that's the one I did the full mod on. I have one of the black cases (unmodded) listed on eBay too. I just haven't gotten around to posting it here.

 

The black one looks nice, but it's such a plain color. The red one, OTOH, looks stunning.

I like the color but that rear panel needs to be red too

 

Unfortunately, I didn't get the tray until after I got the case refinished, and it would have been too cost prohibitive to get just the back panel anodized in red since I had to get it professionally refinished, as I don't have any DIY anodizing equipment. It would be pretty easy to remove the back panel to get it refinished if you happen to know a cheap electroplating shop or have your own DIY equipment.

  • Like 2
Link to comment
Share on other sites

 Share

×
×
  • Create New...