Can't boot windows

[Aardappel]

I have installed iAtkos v7 (Mac OS X 10.5.7) and now I want to start windows at Chamelion but windows gives an error. How to fix this?

[^GoJo^]

Start on Windows install disk, then repair boot, after that, your computer will directly boot on Windows. If you want to have the chameleon loader, then you need to change partition boot flag, i think you can do that with diskpart (win+r, diskpart, select disk, select partition, active).

[Aardappel]

Start on Windows install disk, then repair boot, after that, your computer will directly boot on Windows. If you want to have the chameleon loader, then you need to change partition boot flag, i think you can do that with diskpart (win+r, diskpart, select disk, select partition, active).

 

You mean startup repair? That doens't work. It gives an error at the end.

[eido]

First boot in OS X, and using terminal mark the windows partition as active, THEN reboot and boot from the windows disc, and use startup repair, it should work then. Afterwards you can either use Windows, or reboot and use OS X to set whichever partition you need active

[Aardappel]

First boot in OS X, and using terminal mark the windows partition as active, THEN reboot and boot from the windows disc, and use startup repair, it should work then. Afterwards you can either use Windows, or reboot and use OS X to set whichever partition you need active

 

How to make a partition active in OS X?

[eido]

assuming youre in snow leopard, open up terminal and enter these commands:

 

sudo -s

 

(enter password)

 

fdisk -e /dev/rdisk0

 

p

 

f X (where X is the number of your windows partition - or whatever partition you want to mark active)

 

w

 

y

 

Then quit Terminal and reboot

[Aardappel]

Still can't boot windows.

Status: 0xc000000e

 

Info: The selected entry could not be loaded because the application is missing or corrupt.

 

Ah, I did Disk repair from the windows disk now it works. It didnt work before when the disk wasnt active.

Thanks for the help

 

How to set the Chameleon bootloader to the C disk now?

[eido]

now that youve run setup repair, you should be able to set the OS X partition as active again without causing problems. If you still have a bootdisc of some kind, boot into OS X and do the same procedure as before but mark the OS X partition active. Otherwise, I know theres a way to do it from cmd.exe in windows, but I don't know the commands