Minotour Posted June 7, 2009 Share Posted June 7, 2009 When attempting to install iAtkos (Version v1.0i) disk utility only shows my first hard-drive a Samsung 250gb SATA drive. The problem i have is i wish to install iAtkos onto my 1TB Western Digital Hard-Drive which is also SATA, i created a partition off this so it wouldn't take up all of the drive. However Disk Utility doesn't show the Western Digital or the smaller partition i created. Anyone have any ideas? (BIOS settings are set to IDE for SATA not ACHI if i use ACHI then Vista fails to boot with a BSOD... surprise much?) I am downloading iAtkos 5i - 10.5.5 is it? at the end of the month will that fix my problem? or will i have to swap the SATA cables around? if so how would i go about dual-booting it with Vista then? Cheers if anyone can help Link to comment https://www.insanelymac.com/forum/topic/169618-iatkos-doesnt-see-both-hard-drives/ Share on other sites More sharing options...
Recommended Posts